e. Select Filter > Search.
f. Search for the name of the RPM package that you would like to include in the image and check
the box for it.
3. Click Finish to proceed with creating the image.
4. Click Yes to save the image configuration and start building the image. Refer to the SLEPOS 11 guide
at http://www.novell.com/documentation/slepos11/ for information about image deployment.
Video and serial touch screen configuration
For systems with VIA video chipsets, drivers are packaged separately and must be either installed
manually on a POS system (see “VIA display driver installation and configuration” on page 6) or built
into a SLEPOS image (see “POS client image creation” on page 16). For dual video support, 4846-5x5 and
4840-xx3 are not supported because of X.Org and Intel driver support.
If appropriate for the system that you are configuring, you must also perform the procedures in “Serial
touch screen calibration” on page 3.
Additional package and application installation
Depending upon your environment, you might need to perform one or both of these procedures:
v “JavaPOS packages installation” on page 8
v “RMA packages installation” on page 9
Chapter 3. SUSE Linux Enterprise Point of Service 11 procedures 17
To Next Page
Loading...
