Before installing a rack, read the “Rack safety notices” on page 26.
Completing a parts inventory:
Before beginning the rack installation it is a good idea to do a parts inventory. This section guides you in
performing this task.
If you have not done so, complete a parts inventory before installing the unit in the rack:
1. Locate the kitting report in an accessory box.
2. Ensure that you received all of the features that you ordered and all of the parts on the kitting report.
If there are incorrect, missing, or damaged parts, contact:
v Your IBM reseller
v IBM support (see Directory of worldwide contacts website at IBM Directory of worldwide contacts -
Country/region for contact information for your country)
v IBM Rochester Manufacturing Automated Information Line at 1–800–300–8751 (United States only)
Positioning the rack:
Proper rack positioning is needed to comply with safety and regulatory requirements. Use the procedure
in this section to perform this task.
After the rack has been placed into its location on the floor, lock each caster by tightening the locking
screw. See the following illustration for the locking screw location (2). Remove all the tape and packing
materials from the rack.
1 Caster
2 Locking screw
Use the following to determine the next step:
v To bolt the rack to a concrete floor, go to “Attaching the rack to a concrete floor” on page 4.
Figure 1. Tightening the locking screw
2 Power Systems: Racks and rack features
To Next Page
Loading...
Need help?
General
