IBM 8852 - BladeCenter H Rack-mountable - Page 36

3rd power
module
4th power
module
Power-module
filler
Handle
(open)
Handle
(open)
4. Open the power-module handle, using one of the following procedures:
v For a power module in one of the upper power-module bays, push the inner
handle release to the right; then, pull the handle up to the open position.
v For a power module in one of the lower power-module bays, push the inner
handle release to the left; then, pull the handle down to the open position.
5. Use the handle to pull the module out of the bay.
20 BladeCenter H Type 8852, 7989, and 1886: Installation and User’s Guide