2. Pull the release handle or handles to the open position. The module moves out
of the bay approximately 0.6 cm (0.25 inch).
Note: The modules and fillers in I/O bays 1 through 6 each have one release
handle; the modules and fillers in I/O bays 7 through 10 each have two
release handles.
3. Slide the module out of the bay.
Removing a bezel
When working with some devices, such as the media tray and power modules, you
must first remove the top or bottom bezels to access the devices.
To remove either bezel, complete the following steps.
Release buttons
Release buttons
1. Read the safety information that begins on page v and “Installation guidelines”
on page 18.
2. Press the blue release button on each end of the bezel.
3. Pull the bezel away from the BladeCenter unit.
Chapter 3. Installing the BladeCenter unit and options 23
To Next Page
Loading...
