To Next Page

To Previous Page

46 Brocade 2-Port 10GbE Converged Network Adapter for IBM BladeCenter Installation and User’s Guide

Procedures

Under the Ad No column, 1/0 and 1/1 are the first port and second port respectively on the

first installed adapter while 2/0 and 2/1 are the first and second port on the second installed

adapter.

A maximum of 8 ports can display on a screen. Select Page Up to go to a previous screen or

Page Down to go to the next screen.

2. Select a port that you want to configure.

A screen similar to the following displays. (In the following example, port 0 on the Brocade

1020 adapter was selected.)

3. Select one of the following:

• Adapter Settings. Use the Adapter Settings screen to enable BIOS, port speed (HBAs only),

and auto discovery of boot LUN information on the fabric. You can determine adapter

WWWN and PWWN. Proceed to step 4.

Questions and Answers:

Need help?

Do you have a question about the IBM Brocade and is the answer not in the manual?

IBM Brocade Specifications

General