Name: IBM DJSA-210 - Travelstar 10 GB Hard Drive
Brand: IBM
Rating: 5 (1 reviews)

To Next Page

IBM

Hard disk drive specifications

Travelstar 32GH, 30GT & 20GN

2.5 inch ATA/IDE hard disk drive

DJSA-220

DJSA-205DJSA-230

DJSA-210DJSA-232Models:

Revision 4.0 7 December 2001

S07N-3499-05 Publication #1520

Default Chapter1
- Hard Disk Drive Specifications1
- Table of Contents5
List of Figures11
1 Introduction15
- Abbreviations15
- References17
- General Caution17
- Drive Handling Precautions18
- Figure 1. Drive Handling Precautions18
2 General Features19
Part 1. Functional Specification21
3 Fixed Disk Subsystem Description23
- Control Electronics23
- Head Disk Assembly Data23
4 Fixed Disk Characteristics25
- Default Logical Drive Parameters25
- Formatted Capacity by Model Number25
- Figure 2. Default Logical Drive Parameters25
- Figure 3. Formatted Capacity by Model Number25
- Data Sheet26
- Cylinder Allocation by Model Number26
- Figure 4. Data Sheet26
- Figure 5. Cylinder Allocation by Model Number26
- Performance Characteristics27
5 Data Integrity33
- Data Loss on Power off33
- Write Cache33
- Equipment Status33
- WRITE Safety34
- Data Buffer Test34
- Error Recovery34
- Automatic Reallocation34
- Ecc35
- Figure 14. Examples of Error Cases35
6 Specification37
- Environment37
- DC Power Requirements39
  - Figure 18. DC Power Requirements39
  - Energy Consumption Efficiency40
- Startup Current40
- Figure 19. Energy Consumption Efficiency40
- Figure 20. Typical Current Wave Form at Start up of DJSA-220/210/20540
- Figure 21. Typical Current Wave Form at Start up of DJSA-23041
- Reliability42
- Mechanical Specifications45
- Vibration and Shock48
- Acoustics51
- Identification Labels52
- Electromagnetic Compatibility52
  - CE Mark52
  - C-Tick Mark52
- Safety53
- Packaging53
7 Electrical Interface Specifications55
- Cabling55
- Interface Connector55
- Figure 32. Interface Connector Pin Assignments55
- Signal Definitions56
- Figure 33. Table of Signals56
- Signal Descriptions57
- Figure 34. Special Signal Definitions for Ultra DMA57
- Interface Logic Signal Levels60
- Reset Timings60
- Figure 35. System Reset Timings60
- PIO Timings61
- Figure 36. PIO Cycle Timings61
- Multiword DMA Timings62
- Figure 37. Multiword DMA Cycle Timings62
- Ultra DMA Timings63
  - Initiating Read DMA63
  - Figure 38. Ultra DMA Cycle Timing (Initiating Read)63
  - Host Pausing Read DMA64
  - Figure 39. Ultra DMA Cycle Timings (Host Pausing Read)64
  - Host Terminating Read DMA65
  - Figure 40. Ultra DMA Cycle Timing (Host Terminating Read)65
  - Device Terminating Read DMA66
  - Figure 41. Ultra DMA Cycle Timings (Device Terminating Read)66
  - Initiating Write DMA67
  - Figure 42. Ultra DMA Cycle Timings (Initiating Write)67
  - Device Pausing Write DMA68
  - Figure 43. Ultra DMA Cycle Timings (Device Pausing Write)68
  - Figure 44. Ultra DMA Cycle Timings (Device Terminating Write)69
  - Device Terminating Write Dma69
  - Host Terminating Write DMA70
  - Figure 45. Ultra DMA Cycle Timings (Host Terminating Write)70
- Drive Address Setting71
- Drive Default Address Setting71
- Figure 46. Drive Address Setting71
- Addressing of HDD Registers72
- Figure 47. I/O Address Map72
Part 2. Interface Specification73
8 General75
- Introduction75
- Terminology75
9 Deviations from Standard77
10 Registers79
- Figure 48. Register Set79
- Alternate Status Register80
- Command Register80
- Cylinder High Register80
- Cylinder Low Register80
- Figure 49. Alternate Status Register80
- Data Register81
- Device Control Register81
- Figure 50. Device Control Register81
- Drive Address Register82
- Device/Head Register82
- Figure 51. Drive Address Register82
- Figure 52. Device/Head Register82
- Error Register83
- Features Register83
- Sector Count Register83
- Figure 53. Error Register83
- Sector Number Register84
- Status Register84
- Figure 54. Status Register84
11 General Operation Descriptions85
- Reset Response85
- Diagnostic and Reset Considerations88
- Figure 58. Reset Error Register Values88
- Power-Off Considerations89
- Sector Addressing Mode90
  - Logical CHS Addressing Mode90
- Power Management Features91
- Advanced Power Management (ABLE-3) Feature93
- Function94
- Security Mode Feature Set95
- Protected Area Function102
- Address Offset Feature (Vendor Specific)105
- Seek Overlap108
- Figure 68. Seek Overlap108
- Write Cache Function109
- Delayed Write Function (Vendor Specific)109
  - Enable/Disable Delayed Write Command109
- Reassign Function110
  - Auto Reassign Function110
12 Command Protocol111
- Data in Commands111
- Data out Commands112
- Nondata Commands113
- DMA Data Transfer Commands115
13 Command Descriptions117
- Figure 69. Command Set (1 of 2)117
- Figure 69. Command Set (2 of 2)118
- Figure 70. Command Set (Subcommand)119
- Check Power Mode (E5H/98H)121
- Figure 71. Check Power Mode Command (E5H/98H)121
- Enable/Disable Delayed Write (Fah: Vendor Specific)122
- Figure 72. Enable/Disable Delayed Write Command (Fah)122
- Execute Device Diagnostic (90H)123
- Figure 73. Execute Device Diagnostic Command (90H)123
- Flush Cache (E7H)124
- Figure 74. Flush Cache Command (E7H)124
- Format Track (50H: Vendor Specific)125
- Figure 75. Format Track Command (50H)125
- Figure 76. Format Track Data Field Format126
- Format Unit (F7H: Vendor Specific)127
- Figure 77. Format Unit Command (F7H)127
- Identify Device (Ech)128
- Figure 78. Identify Device Command (Ech)128
- Figure 79. Identify Device Information (1 of 7)129
- Figure 79. Identify Device Information (2 of 7)130
- Figure 79. Identify Device Information (3 of 7)131
- Figure 79. Identify Device Information (4 of 7)132
- Figure 79. Identify Device Information (5 of 7)133
- Figure 79. Identify Device Information (6 of 7)134
- Figure 79. Identify Device Information (7 of 7)135
- Figure 80. Number of Cylinders/Heads/Sectors by Models for DJSA-XXX136
- Identify Device DMA (Eeh)137
- Figure 81. Identify Device DMA Command (Eeh)137
- Idle (E3H/97H)138
- Figure 82. Idle Command (E3H/97H)138
- Idle Immediate (E1H/95H)139
- Figure 83. Idle Immediate Command (E1H/95H)139
- Initialize Device Parameters (91H)140
- Figure 84. Initialize Device Parameters Command (91H)140
- Read Buffer (E4H)141
- Figure 85. Read Buffer Command (E4H)141
- Read DMA (C8H/C9H)142
- Figure 86. Read DMA Command (C8H/C9H)142
- Read Long (22H/23H)144
- Figure 87. Read Long Command (22H/23H)144
- Read Multiple (C4H)146
- Figure 88. Read Multiple Command (C4H)146
- Read Native Max ADDRESS (F8H)148
- Figure 89. Read Native Max ADDRESS (F8H)148
- Read Sectors (20H/21H)150
- Figure 90. Read Sectors Command (20H/21H)150
- Read Verify Sectors (40H/41H)152
- Figure 91. Read Verify Sectors Command (40H/41H)152
- Recalibrate (1Xh)154
- Figure 92. Recalibrate Command (1Xh)154
- Security Disable Password (F6H)155
- Figure 93. Security Disable Password Command (F6H)155
- Figure 94. Password Information for Security Disable Password Command155
- Security Erase Prepare (F3H)156
- Figure 95. Security Erase Prepare Command (F3H)156
- Security Erase Unit (F4H)157
- Figure 96. Security Erase Unit Command (F4H)157
- Figure 97. Erase Unit Information157
- Security Freeze Lock (F5H)159
- Figure 98. Security Freeze Lock Command (F5H)159
- Security Set Password (F1H)160
- Figure 99. Security Set Password Command (F1H)160
- Figure 100. Security Set Password Information161
- Security Unlock (F2H)162
- Figure 101. Security Unlock Command (F2H)163
- Seek (7Xh)164
- Figure 102. Security Unlock Information164
- Sense Condition (F0H: Vendor Specific)165
- Figure 103. Seek Command (7Xh)165
- Set Features (Efh)166
- Figure 104. Sense Condition Command (F0H)166
- Figure 105. Set Features Command (Efh)167
- Set Max ADDRESS (F9H)168
- Figure 106. Set Max ADDRESS (F9H)169
- Set Multiple (C6H)170
- Sleep (E6H/99H)171
- Figure 107. Set Multiple Command (C6H)171
- Function Set (B0H)172
  - Figure 108. Sleep Command (E6H/99H)172
  - Figure 109. S.M.A.R.T. Function Set Command (B0H)173
  - Function Subcommands173
  - S.M.A.R.T. Function Subcommands174
  - Figure 110. Log Sector Addresses175
  - Device Attributes Data Structure177
  - Figure 111. Device Attribute Data Structure178
  - Figure 112. Individual Attribute Data Structure179
  - Figure 113. Status Flag Definitions180
  - Device Attribute Thresholds Data Structure182
  - Figure 114. Device Attribute Thresholds Data Structure183
  - Error Log Sector184
  - Figure 115. Individual Threshold Data Structure184
  - Figure 116. S.M.A.R.T. Error Log Sector185
  - Figure 117. Error Log Data Structure186
  - Figure 118. Command Data Structure186
  - Figure 119. Error Data Structure187
  - Self-Test Log Data Structure187
  - Error Reporting188
  - Figure 120. Self-Test Log Data Structure188
- Standby (E2H/96H)189
- Figure 121. S.M.A.R.T. Error Codes189
- Standby Immediate (E0H/94H)190
- Figure 122. Standby Command (E2H/96H)190
- Write Buffer (E8H)191
- Figure 123. Standby Immediate Command (E0H/94H)191
- Write DMA (Cah/Cbh)192
- Figure 124. Write Buffer Command (E8H)192
- Figure 125. Write DMA Command (Cah/Cbh)193
- Write Long (32H/33H)194
- Figure 126. Write Long Command (32H/33H)195
- Write Multiple (C5H)196
- Figure 127. Write Multiple Command (C5H)197
- Write Sectors (30H/31H)198
- Write Verify (3Ch: Vendor Specific)199
- Figure 128. Write Sectors Command (30H/31H)199
14 Time-Out Values201
- Figure 129. Time-Out Values201
15 Appendix203
- Commands Support Coverage203
- Figure 130. Command Coverage (1 of 2)203
- Figure 130. Command Coverage (2 of 2)204
- SET FEATURES Command Support Coverage205
- Changed Points from DARA-XXXXXX205
- Figure 131. SET FEATURES Command Coverage205
Index207

IBM DJSA-210 - Travelstar 10 GB Hard Drive User Manual

Table of Contents

Questions and Answers:

IBM DJSA-210 - Travelstar 10 GB Hard Drive Specifications

Related product manuals

Brand	IBM
Model	DJSA-210 - Travelstar 10 GB Hard Drive
Category	Storage
Language	English