Need help?Do you have a question about the IBM DJSA-210 - Travelstar 10 GB Hard Drive and is the answer not in the manual?
Product line for hard disk drive specifications.
List of abbreviations and their meanings used in the document.
General warnings and precautions for handling the drive.
Lists formatted capacities for different drive models.
Specifies the maximum data transfer rate.
Specifies shock resistance levels during drive operation.
Describes the main components of the fixed disk subsystem.
Lists default logical drive parameters by model number.
Details formatted capacity for each drive model.
Summarizes key technical specifications in a data sheet format.
Defines command overhead time from command receipt to actuator motion.
Details mechanical positioning performance, including seek times.
Describes different operating modes of the drive.
Defines operating and non-operating temperature and humidity limits.
Specifies the nominal DC supply voltage and ripple requirements.
Lists typical power consumption in Watts for various operating modes.
States the probability of data recovery and ECC implementation.
Explains the S.M.A.R.T. function for failure prediction.
Lists physical dimensions and weight for different models.
Shows mounting hole positions for drive installation.
Specifies vibration levels the drive can withstand during operation.
Specifies shock resistance levels during operation.
Specifies shock resistance levels when not operating.
Details the 50-pin AT interface connector and pin assignments.
Lists and defines the interface signals and their pin assignments.
Specifies timings for initiating DMA read transfers.
Specifies timings for initiating DMA write transfers.
Explains how HDD registers are addressed via I/O space.
Provides general information about the host interface.
Describes different power modes like Sleep, Standby, Idle, and Active.
Lists commands related to managing power states.
Defines attributes for analyzing device status and predicting faults.
Explains how attribute values represent reliability.
Describes different security modes: Locked, Unlocked, and Frozen.
Details the types of passwords (Master, User) and their usage.
Shows command support based on security mode.
Explains how to enable or disable the Address Offset mode.
Lists commands that transfer data from the device to the host.
Lists commands that transfer data from the host to the device.
Describes the Identify Device command.
Describes the Security Disable Password command.
Details the Set Features command for configuration.
Specifies time-out values for Data In commands.
Specifies time-out values for Data Out commands.
Specifies time-out values for Non-Data commands.
Shows command support coverage compared to ATA-4 standards.
Lists SET FEATURES command support coverage.
To Next Page
General