For more information about security requirements, see .
Selecting browser security settings
You must select the appropriate web browser security settings to access the DS8000
Storage Management GUI. In Internet Explorer, use the following steps.
1. On the Tools menu, click Internet Options.
2. On the Security tab, select Internet and click Custom level.
3. Scroll to Miscellaneous, and select Allow META REFRESH.
4. Scroll to Scripting, and select Active scripting.
Configuring Internet Explorer to access the DS8000 Storage
Management GUI
If DS8000 Storage Management GUI is accessed through IBM Spectrum Control
with Internet Explorer, complete the following steps to properly configure the web
browser.
1. Disable the Pop-up Blocker.
Note: If a message indicates that content is blocked without a signed by a valid
security certificate, click the Information Bar at the top and select Show
blocked content.
2. Add the IP address of the DS8000 Hardware Management Console (HMC) to
the Internet Explorer list of trusted sites.
For more information, see your browser documentation.
Chapter 1. Overview 39
To Next Page
Loading...
Need help?
General