EasyManuals Logo

IBM DS8884 Series User Manual

IBM DS8884 Series
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
The main power area is at the rear of the expansion frame. The power system in
each frame is a pair of direct-current uninterruptible power supplies (DC-UPSs)
with internal batteries.
Storage enclosures
DS8880 version 8.2 and later integrates one of two types of storage enclosures:
High Performance Flash Enclosures Gen2 and standard drive enclosures.
High Performance Flash Enclosures Gen2 pair
The High Performance Flash Enclosure Gen2 is a 2U storage enclosure that is
installed in pairs.
The High Performance Flash Enclosure Gen2 pair provides two 2U storage
enclosures with associated RAID controllers and cabling. This combination of
components forms a high-performance, fully-redundant flash storage array.
The High Performance Flash Enclosure Gen2 pair contains the following hardware
components:
v Two 2U 24-slot SAS flash drive enclosures. Each of the two enclosures contains
the following components:
– Two power supplies with integrated cooling fans
– Two SAS Expander Modules with two SAS ports each
– One midplane or backplane for plugging components that provides
maintenance of flash drives, Expander Modules, and power supplies
v Two High Performance Flash Enclosure Gen2 flash RAID adapters configured
for redundant access to the 2U flash enclosures. Each RAID adapter supports
concurrent maintenance and includes the following components:
– High Performance ASIC RAID engine
– Four SAS ports and cables connected to the four SAS Expander Modules
providing fully-redundant access from each RAID adapter to both 2U
enclosures
– Integrated cooling
– x8 PCIe Gen2 cable port for direct connection to the I/O enclosure
Standard drive enclosures
The standard drive enclosure is a 2U storage enclosure that is installed in pairs.
Each standard drive enclosure contains the following hardware components:
v Up to 12 large-form factor (LFF), 3.5-inch drive enclosures
v Up to 24 small form factor (SFF), 2.5-inch SAS drives
Note: Drives can be disk drives or flash drives (also known as solid-state drives
or SSDs). You cannot intermix drives of different types in the same enclosure.
v Two power supplies with integrated cooling fans
v Two Fibre Channel interconnect cards that connect four Fibre Channel 8 Gbps
interfaces to a pair of device adapters or another standard drive enclosure.
v One back plane for plugging components
The 2.5-inch disk drives and flash drives (SSDs) are available in sets of 16 drives.
The 3.5-inch SAS disk drives are available in half-drive sets of eight drives.
Chapter 1. Overview 21

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM DS8884 Series and is the answer not in the manual?

IBM DS8884 Series Specifications

General IconGeneral
BrandIBM
ModelDS8884 Series
CategoryStorage
LanguageEnglish

Related product manuals