e. Move the carrier latch to the locked position. If the carrier does not lock,
check that the drive carrier is fully seated in the backplane. When the drive
carrier is fully seated and power is turned on, the Ready LED on the drive
carrier illuminates.
5. See “Disk Drive Status LED States” on page 2-18 for information on disk drive
lights.
6. Go to Table A-2 on page A-4 to record the drive location for the drive; then
return here to determine your next step.
7. If you have other drives to install, go to page 5-43.
8. If you have other procedures to perform, refer to “Option List” on page 5-17.
9. If you do not have any other procedures to perform, replace the covers as
described in “Replacing the Front Covers” on page 5-93.
5-58 IBM RS/6000 7025 F50 Series User's Guide
To Next Page
Loading...
