IBM IntelliStation A Pro - ServeRAID Manager Usage

13. Install the new microprocessor:
a. Touch the static-protective package containing the new microprocessor to
any unpainted metal surface on the computer; then, remove the
microprocessor from the package.
b. Position the microprocessor over the microprocessor socket as shown in
the following illustration. Carefully press the microprocessor into the socket.
Attention: To avoid bending the pins on the microprocessor, do not use
excessive force when pressing it into the socket.
Microprocessor
Microprocessor
orientation indicators
Microprocessor
socket
14. Close the microprocessor-release lever to secure the microprocessor.
Attention:
v Do not disturb or contaminate the grey thermal material on the bottom of the
new fan sink. Doing so damages its heat-conducting capability and exposes
the new microprocessor to overheating.
v If you need to remove the fan sink after installing it, call for service.
Chapter 2. Installing the hardware 35