24
Motherboard Users Guide
Read to Precharge (Trtp)
This item defines the precharge operation always starts one clock following the
Read command, independent of CAS Latancy.
Write to Read CMD
This item species CMD between a valid write command and the next read com-
mand.
Write Recovery Time
Use this item to specify the time measured from the last write datum is safely
registered by the DRAM.
DRAM Command Rate
When the host (northbridge locates the desired memory address, it then processors
the wait state of commands.
RDSAIT mode
This item enable or disable the RDSAIT mode.
RDSAIT selection
This item enable or disable to select the RDSAIT mode.
Phonex-AwardBIOS CMOS Setup Utility
AGP & P2P Bridge Control
Help Item
AGP Aperture Size [128M]
AGP3.0 Mode [8X]
AGP Driving Control [Auto]
AGP Driving Value DA
AGP Fast Write [Disabled]
AGP Master 1 WS Write [Enabled]
AGP Master 1 WS Read [Enabled]
AGP 3.0 Calibration cycle [Disabled]
TotalMemory with VGA memor[64M]
Direct Frame Buffer [Enabled]
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F5: Previous Values F6: Fial-Safe Defaults F7: Optimized Defaults
AGP & P2P Bridge Control (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
f
Menu Level
ff
To Next Page
Loading...
Need help?
General
