Figure 138. Connecting the power cords to a stand-alone system
8. Start the system. For instructions, see Starting a system (www.ibm.com/support/knowledgecenter/
POWER9/p9haj/crustartsys.htm).
9. Turn off the identify LED. For instructions, see Deactivating an identify LED (www.ibm.com/support/
knowledgecenter/POWER9/p9haj/p9haj_turn_off_identify_led.htm).
10. Verify whether the control panel display is operational by checking the progress codes.
Control panel cables for the 9009-41A, 9009-42A, or 9223-42H
143
To Next Page
Loading...
