Figure 15. Location of the control panel LED in a stand-alone system
Removing the control panel from the 9009-41A, 9009-42A, or 9223-42H system
To remove a control panel, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. For a rack-mounted system, loosen the screw (B) that secures the control panel (A) to the bracket as
shown in Figure 16 on page 18
.
Control panel and control panel display for the 9009-41A, 9009-42A, or 9223-42H
17
To Next Page
Loading...
