Figure 35. Plugging in the power cords and securing the cables with fasteners
9. If you have a disk drive enclosure or expansion drawer that came preinstalled in this rack, use the
documentation supplied with these options. For information about connecting enclosures and
expansion units, see Enclosures and expansion units (http://www.ibm.com/support/
knowledgecenter/POWER9/p9ham/p9ham_kickoff.htm).
10. Attach the PDU input power cord and plug it into the power source.
Cabling the server and setting up a console
Your console, monitor, or interface choices are guided by whether you create logical partitions, which
operating system you install in your primary partition, and whether you install a Virtual I/O Server (VIOS)
in one of your logical partitions.
Determining which console to use
There are different console types available to manage this server. Learn more about the consoles that are
available.
Go to the instructions for the applicable console, interface, or terminal in the following table.
Installing the IBM Power System E950 (9040-MR9)
43
To Next Page
Loading...
Need help?
General