Figure 17. Securing the rail to the rack
9. While you hold the rail bracket in place, carefully expand the rail until the other end reaches the
opposite rack flange.
10. Seat the pins of the opposite rail bracket in the marked mounting holes.
11. At the rear of the rail, close the rear hinge bracket to secure the rail to the rack cabinet flange.
12. Install one M5 screw (C) in the open hole in the bracket between the two alignment pins at the rear of
the rack.
13. Repeat steps “6” on page 16 - “12” on page 18 for the other rail.
Installing the 5887 disk drive enclosure into the rack
Learn how to install the 5887 disk drive enclosure into the rack. In addition to related safety information,
illustrations of the related hardware components are provided.
Before you begin
Important: Two people are required to safely lift the enclosure. Using fewer than two people to lift the
enclosure can result in injury.
18
Power Systems: Installing the 5887 disk drive enclosure
To Next Page
Loading...
Need help?
General