Attention: To prevent damage to the card and to the card connectors, open
and close the retainer latches at the same time.
5. Place the memory card into the card guide rails.
6. Align the card with the connector.
7. Firmly insert the card into the connector.
8. Close the retainer latches to secure the card into the connector.
9. Make sure that the black tabs on the new card are captured by the the latches.
10. Install the memory card shield between the two memory cards.
11. Replace the processor and memory card cover “Replacement of Processor and
Memory Card Cover” on page 7-10.
12. Replace the system unit covers as described in “Replacement of Covers” on
page 7-9.
Chapter 7. Removal and Replacement Procedures 7-13
To Next Page
Loading...
