Removal of Disk Drives from Carrier
1. If you have not already done so, remove the drive and carrier from the system
unit. See “Removal of Disk Drives” on page 7-23 for instructions.
2. Loosen and remove screws A and B first.
3. Loosen and remove screws C and D.
4. Remove the drive from the carrier.
Installation of Disk Drives into Carrier
1. Align the drive with the carrier so that ...
2. Insert the unit into the carrier.
3. Insert and tighten the screws in the following order:
A
B
C
D
A
B
C
D
Chapter 7. Removal and Replacement Procedures 7-25
To Next Page
Loading...
