IBM RS/6000 7043 43P Series - Page 171

8. Install any adapters you removed into their original connectors. If you need
further information on installing adapters, see “Installing Adapters” on page 4-70.
9. Go to “Device Records” on page A-3 and update the system information. Return
here to continue.
What to do next?
To enable or disable:
 The privileged-access password, go to page 4-14.
 The automatic power-up feature, go to page 4-19.
 The power-on password, go to page 4-9.
 The external SCSI connector, go to page 4-102.
To install:
 A memory module, go to page 4-24.
 An L2 cache card, go to page 4-34.
 A 200-MHz or 233-MHz processor upgrade for the Model 140, go
to page 4-38.
 A 332-MHz processor upgrade for the Model 140, go to page
4-50.
 A processor card for the Model 240, go to page 4-63.
 An adapter, go to page 4-70.
 Cabling for an Ultra SCSI adapter, go to page 4-82.
 An internal drive, go to page 4-88.
 A security tether, go to page 4-106.
 A new battery, go to page 4-108.
To remove:
 An adapter, go to page 4-80.
 A memory module, go to page 4-30.
 A processor card, go to page 4-67.
 An internal drive, go to page 4-88.
To complete the installation, go to page 4-113.
Chapter 4. Installing and Removing Options 4-69