Table 3-1 (Page 10 of 26). Firmware Error Codes.
Error Code Description Action / Possible Failing FRU
28030xxx RTC errors 1. Errors reported against the Real
Time Clock (RTC) can be caused
by low battery voltage and (more
rarely) power outages that occur
during normal system usage.
These errors are warnings that the
RTC data content needs to be re-
established and do not require any
FRU replacement unless the error
is persistent. When one of these
errors occurs, the Power On Pass-
word and Time and Date informa-
tion has been lost.
To set/restore a Power On
Password, use the SMS utility.
To set/restore the Time and
Date, use the Operating
System facility.
2. If the error is persistent, replace
the battery.
3. If the error is persistent after
battery replacement, replace the
I/O board. (See notes on 3-1.)
28030001 RTC initialization required- RTC not
updating, corrected.
Refer to Action under error code
28030xxx.
28030002 Bad time/date values 1. Set the time and date.
2. Refer to Action under error code
28030xxx.
29000002 Keyboard/Mouse controller failed self-
test.
Replace the I/O board. (See notes on
3-1.)
29A00003 Keyboard not present/detected. 1. Keyboard
2. Replace the I/O board. (See notes
on 3-1.)
29A00004 Keyboard stuck key test failed. 1. Keyboard
2. Replace the I/O board. (See notes
on 3-1.)
29B00004 Mouse not present/detected. 1. Mouse
2. Replace the I/O board. (See notes
on 3-1.)
2B200402 Unsupported Processor. CPU Card.
Chapter 3. Error Code to FRU Index 3-11
To Next Page
Loading...
