IBM SAN48B-5

Attaching the rear brackets to the front brackets
Complete the following steps to attach the rear brackets to the front brackets.
1. Position the right rear bracket 2 inside the right front bracket 1, as shown
in Figure 6.
2. Attach the brackets using four 6-32 x 1/4 in. screws 4.
3. Adjust the brackets to cabinet depth and tighten the screws to a torque of 9
in-lb (10 cm-kg).
4. Repeat step 1 through step 3 to attach the left rear bracket 3 to the left front
bracket.
4
2
3
1
b48f003
Figure 5. Position the switch in the cabinet
2
1
3
4
b48f004
Figure 6. Position the rear and front brackets
12 SAN48B-5 Installation, Service, and User Guide