EasyManuals Logo

IBM System/36 User Manual

IBM System/36
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Assigning
Work
Station
Addresses
Besides
the
system console
and
its
attached
PC
printer,
your
system
can
have
additional
local
work
stations,
as
well
as
remote
work
stations,
which
are
attached
through
a remote
controller.
You
must
identify
each
device
to
the
system
with
a device code
and
a work
station
address, so
the
system
knows
what
model
the
device
is
and
where
on
the
line
the
device
is
located.
•
For
local
work
stations,
use
Form
F, Local Work Station
Diagram to:
Assign
the
addresses
Record
the
device codes
Note: Device codes are used
during
system configuration
to
identify the particular model
of
the display stations
and
printers.
•
For
remote
work
stations,
use
Form
H
if
you
have
a 5251-12
remote
controller,
Form
Hl
if
you
have
a
5294-1
remote
controller,
or
Form
H2
if
you
have
a 3274
remote
controller.
You will also need a copy
of
the
Communications Network Setup
Form
that
was completed for
the
remote
controller
from
the
manual
5250
Installation
and
Site Preparation Guide.
The
F
and
H forms
are
in
Appendix
C.
You will
use
the
addresses
when
you
label
the
cables
and
also
later,
during
setup,
when
you
actually
attach
the
work
stations
to
the
computer.
You
will
use
the
device codes (listed
later
in
this
book)
when
you
configure
the
system.
6
Preparing
to
Install
Your
Work
Stations
- 5364

Table of Contents

Other manuals for IBM System/36

Preview: Maintenance Information Manual
Maintenance Information Manual178 pages

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IBM System/36 and is the answer not in the manual?

IBM System/36 Specifications

General IconGeneral
BrandIBM
ModelSystem/36
CategoryDesktop
LanguageEnglish

Related product manuals