IBM System/36 - Assembly Instructions

Assembly Instructions
If you purchase bulk twinaxial cables, assemble them as follows.
Refer to the illustrations following these instructions for
dimensions and assistance in doing these procedures. If you use
connectors provided by a company other than IBM, use the
instructions provided by the manufacturer.
1. Be certain that the connector kit has all of the required parts.
Check the cross-sectional diagram for location of the cable
layers.
Clamp Nut
Clamp Gasket
Twinaxial Cable
Jacket
Wire Shield
Cable Core Insulation
Conductor Insulation
Conductor
Braid Clamp--------~~
Sleeve---------~.....,
Contacts ---
Insulator---._ ~
Plug Body\ ----- ~
"
Twinaxial Connector
(IBM part 7362229)
R9476067-2
34 Preparing to Install Your Work Stations - 5364