IBM System/370 - Page 253

DASD, 1/0 command codes for, 2-7
deblock utility, 6-2
disk drive - 3340, 5-28
diskette, 5-30
display console
3270, 5-49
3277, 5-47
DOSNS DOC commands, 4-80
OSNS display console commands, 4-83
OSNS display console operation (Mod 158), 5-47
starting DOSNS with DOC, 4-84
starting OSNS with, 5-47
display screen areas
Mod 125, 5-44
Mod 158, 5-45
Mod 168, 5-46
display main storage
see CPU manual procedures
display PSW
see CPU manual procedures
display registers
see CPU manual procedures
DITTO DOSNS utility, 6-3, 6-6
DOSIVS IPl commands, 4-1
DOSNS job control and attention routine commands, 4-5
DOSNS POWER commands, 4-20
task management, 4-20
queue management, 4-21
DOSNS POWER RJE commands, 4-22
DOSNS system utilities, 6-1
Dynamic Address Translation (DAT), 2-15
edit subcommands CRJE, 4-76
EDIT and EDMK pattern characters, 2-3
error restart procedures
see restart procedures
extended mnemonic instructions, 2-3
fast copy disk volume utility, 6-2
fixed storage locations, 2-14
floating point instructions, 2-2
glossary, 7-1
hardstop option
see CPU manual procedures
HASP II commands, 4-43
hexadecimal-decimal conversion, 2-15
hexadecimal table, 2-15
IBCDASDI utility, 6-8
IEBISAM utility, 6-7
IEBPTPCH utility, 6-7
IEHDASDR utility, 6-7
IEHlIST utility, 6-7
IEHMOVE utility, 6-7
IMPl procedure
see
CPU manual procedures
IPl DOSNS commands, 4-1
IPl DOSIVS procedure, 4-84
IPl OSIVS procedure
see
CPU manual procedures
IPl VSl (ReI. 2) example, 4-86
IPl VS2 (Rei. 1.6) example, 4-88
IP l VS2 (Rei. 2) example, 4-89
initialize data cell utility, 6-2
initialize disk utility, 6·2, 6-4
initialize tape utility, 6-2, 6-4
input/output
command codes, 2-6
devices list, 5-2
restart procedures, see restart procedures