IBM System/370

DOSIVS Job Control and Attention Routine Commands (cont'd)
Name
Operation
Operand
Remarks
Accepted
by
OPTION
USRLABEL
Causes all DASDortape
(Cont'd)
labels to be written on
the user labe I track
PARSTD
Causes all DASDortape
labels to
be written on
the partition standard
label
track
48C
48-character set
60C
6O-character set
SYSPARM= Specifiesavalueforas-
semblersystemvariable
symbol and
SYSPARM
[Ill
OVEND
[comments]
Indicates end of overwrite state-
JCS
ments for a
cata loged procedure
JCC
VI]
PAUSE [commentsl Causes pause immediately after pro-
JCS
cess ing th is statement. PAUSE state-
JCC
ment is always printed on SYSLOG.
If no 3210,3215 or DOC is available
the statement is ignored.
PAUSE
[{!!Q} [ EOJ1l
Causes
pause at end of current job AR
Fn' J
step or at end of job
where n=
1,2,30r4
PRTY [p I, P2 [, P3 [, P4[, P5]]J]
Pn= BG,F 1 ,F2,F30rF4.Allowsthe
AR
operator to disp lay or change the
priority of partitions
VI]
RESET
{~6G )
Resets
i/O device assignments JCS
JCC
ALL
SYSxxx
ROD
blank
Causes a II SDR counters for a II non-
JCC
te leprocess i ng dey ices on the recor-
der fi Ie on SYSREC to be updated from
the SDR counters in main storage
II
RSTRT
SYSxxx, nnnn [, file- SYSxxx:
Symbolic unit
nameofthe
JCS
name]
device on which the check
point records
are stored.
Can be SYSOOO-SYSnnn
nnn:
four character ident ifica-
tion of the checkpaint re-
cord to be used for restart
filename:
symbolic name of the
DASDfile to be used for
restarting
SET
r, UPSI=value 1]
valuel:O,1 or X
IJCC
[, L1NECT=value21
value2:standard number of lines for
[,RCLST=value3J
output on
each page of SYS LST
[, RCPCH=value41
value3:decimal number indicating
[,RF=value5]
minimum number of
SYSLST disk re-
[, DATE=value6l
cords remaining to
be written before
[,
HC=va lue7l
operator warning
Page 4-15