IBM System/370 - Page 83

DOS/VS Job Control and Attention Routine Commands (cont'd)
Namej Operation 1 Operand I
Remarks
I Accepted
i by
II
II
I
!
TLBL Note: For ASCII file 1
(Cont'd) processing the fourth I
and fifth operands are '
called set identifier
and file section
number, respectively
!
Cfile serial number (EBCDIC): }
One to six alphameric charac-
~;~~dentifier (ASCII) : Six I
a Iphamer i c characters] I
[volume sequence number n'
(EBCDIC)J •
g~~e t:e~~~~nn::~i: ~~;r~~I;eJrs I
file sequence nur:ber : One to four!
numenc characters I
generation number: One to four '
numeric characters
version
number: One to two
numer
i c characters
TPLAB
'label fields 3-10' ! 'label fields 3-10': Indicated JCS
fie Ids of the standard tape f!le
label
for either EBCDIC
or ASCII. A 49-byte
character string,
contained within
apostrophes
I TPLAB
'label fields 3-10 C i
label fields 11-13'
'label fields 3-10': same as above 'I JCS
C: Any nonblanc character
I
i
UCS
in column 72 I
label fields 11-13' : 20 character I
~~:e~~;:~~:~:;!:~ s~ingi
begun with fields 3-10 :
(no
blanks, apostrophes 'I'
or commas separating)
SYSxxx, phasename ! Causes the 240-character universal
[, FOLD] L BLOCK] character set contained in the core
[,NULMSGJ I image library phase specified by
phcsename to
be loaded as buffer
storage
in the IBM 2821 CU.
SYSxxx must be assigned TO a 1403
or 5203 Printer with the
UCS
I feature.
JCC
I UNBATCH: blank
Terminates foreground processing
I JCC
II UPS I ; nnnnnnnn
0, lor X i JCS
II
VOL
SYSxxx,
filename
SYSxxx:
Can be SYSOOO-SYSnnn i JCS
filename: One to seven alpha-
meric characters, the
first of which must be
alphabetic
I
i
1
Page 4·17