IBM System/370

DOSIVS POWER Commands (cont'd)
RJE Management Console Operator Commands
Operation Operand Camments
rrmid }
BROADCAST Send a message la a
B
M, ~erid , 'msg'
specific user or to
ALLUSERS all terminal users
(ALLUSERS)
r·"Od )
B
L, userid[,nrl
De lete message(s) for
ALLUSERS[,nr 1
a
specific user or all
ALL
messages (nr= 1-99)
rrmid[,nrJ }
Display message(s) for a
B
D, userid[,nr] specific terminal user
ALLUSERS[,nr] or
ALLUSERS (nr= 1-99)
INQUIRE about RJ E task status for
I
U,userid
a
specific userid
I
T,termid
a specific termid
I
L,cuu
a specific line
I
ALL
ALL valid terminal
designations
["""" II J
CHANGE
0
jname, I jnr I, userid , PRT OUTPUT
destination of a job
ALLUSERS , PUN
to a
specific user, to
LOCAL
a loca
I autput dev ice
or ta all terminal
users on a read only
basis
(ALLUSERS)
FORMAT OF Q's
[,AUTOSTART ]
?
Explanation:
Operator response:
Page 4-22
!~~I_~ ckll'ing pt"Jrlition initialization and is in two parts:
1) Format Q's - format queues or warm start
2) Autostart - (only is specified as a generation option) whether
the reader/writer devices should be automatically initiated
or nat
[Q,][D,][A,][~~] (EOB) where
1) Response to format Q's is
Q- format af Q'ILE records.
D- format DATAFIL and Q'ILE records
A- format ACCTFIL records
These parameters may be specified in any order. If none
of the above is specified, no formatting occurs
..
2) Autostart IS speCIfIed CIS •
YES - Initiate reader/writer devices. Default is amitted
NO - Da not initiate reader/writer devices
I