Installing hardware devices in the memory expansion module
The following sections provide detailed instructions for installing optional
hardware devices in the optional IBM MAX5 for System x memory expansion
module.
Memory expansion module components
The following illustration shows the major components in the memory expansion
module. The illustrations in this document might differ slightly from your
hardware.
Removing the memory expansion module bezel
To remove the memory expansion module bezel, complete the following steps:
1. Read “Safety” on page v and “Installation guidelines” on page 38.
2. Press in on the release tabs on both ends of the bezel and pull it off the chassis.
Chapter 2. Installing optional devices 81
To Next Page
Loading...
Need help?
General