Getting Started 1-5
Emulator-Opened
Sessions
If you have specified an IP address in your connection definition, then once
connected the Pass Through Screen displays (see Figure 1-2).
Figure 1-2 Pass Through Screen
An initial session has been opened by the emulator. From the Pass Through
Screen, press
Ctrl
(right) to go to the first open session. To open subsequent
sessions, press
Alt
+
?
. The main menu will display. Use the Sessions menu to
open more sessions.
User-Opened
Sessions
If you have not specified an IP address in your connection definition, then
Main Menu - TN5250 displays (the main menu of the TN5250 user interface).
Use this menu to open your initial session. You will need to open a session to
continue.
❖
Note See Chapter 2, “The Menu System,” for further instructions about
navigating through the TN5250 terminal emulation menu system.
To open a session:
1 Position the cursor at Open Session.
2 Press
Ctrl
.
Pass Through Screen
Type choices, Press Enter.
Remote location name AS400A
Mode name LU62APPC
Virtual controller QPACTL00
Virtual display device ___________
Remote network identifier ___________
Local PU name MKPTU3
Local LU name ___________
To Next Page
Loading...
Need help?
General
