Installing a CD or DVD drive
Tape drive
EMC shield
Filler panel
Drive retainer clip
To install a CD or DVD drive, complete the following steps:
1. Read the safety information that begins on page v and “Installation guidelines”
on page 18.
2. Turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
3. Remove the side cover (see “Removing the side cover” on page 21).
4. Remove the two-piece bezel (see “Removing the two-piece bezel” on page
22).
5. Use a screwdriver to pry the filler panel and EMC shield away from the server.
28 System x3200 Types 4362 and 4363: User’s Guide
To Next Page
Loading...
