Installing a hot-swap power supply
The following notes describe the type of power supply that the server supports and
other information that you must consider when you install a power supply:
v The type and number of power supplies vary by server model. The server comes
with at least one power supply.
v Some servers come with a hot-swap power supply that supports redundant
mode. The redundant mode requires two operational hot-swap power supplies in
the server.
This
procedure applies only to server models that have hot-swap power supplies. If
the server contains a non-hot-swap power supply that requires replacement, the
power supply must be replaced by a service technician.
When you remove or install a hot-swap power supply, observe the following
precautions.
Statement 8:
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any
component that has this label attached. There are no serviceable parts inside
these components. If you suspect a problem with one of these parts, contact
a service technician.
Hot-swap power
supply
Release lever
To replace a hot-swap power supply, complete the following steps:
Chapter 2. Installing optional devices 39
To Next Page
Loading...
