IBO MAGI 25-100/180 User Manual (English)

Other manuals for IBO MAGI 25-100/180

Questions and Answers:

C
Christopher PerezAug 11, 2025
What to do if my IBO MAGI 25-100/180 Water Pump fails to launch?
- R
  roger31Aug 11, 2025
  If your IBO Water Pump fails to launch, there are several potential causes. First, check if the installation fuse has tripped and replace it if necessary. Also, verify that the overcurrent circuit breaker hasn't switched off, and restart it if it has. If the voltage is too low, ensure the main voltage complies with the supplier's specifications. A blocked pump rotor could also be the issue, so try unlocking it. In the worst-case scenario, the pump may be damaged and require replacement.
Z
zhaynesAug 18, 2025
Why is my IBO Water Pump operation so loud?
- M
  Matthew WalkerAug 18, 2025
  If your IBO Water Pump is operating loudly, it could be due to air in the pump. Try venting the pump to remove any trapped air. Another possible cause is inflow pressure that's too low, leading to cavitation. Increasing the inflow pressure at the pump's inlet might resolve this issue.
U
uleeAug 26, 2025
Why is my IBO MAGI 25-100/180 system operation so loud?
- E
  Eric SanchezAug 26, 2025
  Loud system operation in your IBO Water Pump can stem from a couple of issues. There might be air trapped in the installation, so venting the system is recommended. Alternatively, the flow could be too high. In this case, decreasing the inflow pressure at the pump inlet should help.
R
Robert SmithSep 3, 2025
What to do if there is heat insufficiency in the IBO MAGI 25-100/180 Water Pump installation?
- B
  Brandon LeeSep 3, 2025
  If you're experiencing heat insufficiency in your IBO Water Pump installation, the pump parameters might be too low. If possible, try increasing the pump operation mode to a more efficient setting. If that doesn't suffice, consider installing a stronger pump.

IBO MAGI 25-100/180 Specifications

General

Model	IBO MAGI 25-100/180
Type	Centrifugal Pump
Power	18.5 kW
Voltage	230 V
Frequency	50 Hz
Material	Cast Iron
Maximum working pressure	10 bar
Mounting length	180 mm
Max Flow Rate	100 L/min
Max Head	10 m
Liquid temperature range	2°C to 110°C