Need help?Do you have a question about the IBO OHI Single-phase pipeline Series and is the answer not in the manual?
General| Maximum working pressure | 10 bar |
|---|---|
| Frequency | 50Hz |
| Category | Water Pump |
| Model | OHI |
| Application | Water supply |
| Motor power | Up to 2.2 kW (depending on the specific model) |
| Inlet/Outlet | 2" |
| Pump body material | Cast iron |
Pump bearings are water-lubricated; dry running must not exceed 10 seconds.
Ambient temperature must be lower than the temperature of the pumped medium.
Pump must be installed horizontally, ensuring the motor shaft remains horizontal.
Follow specific procedures shown in Picture 4 for pump installation.
Use qualified electricians for electrical connections as per regulations; do not self-install.
Carefully read all warnings before proceeding with installation.
The pump must be deflated before operation for the first time after installation.
Damaged power cords must be replaced by the factory or a qualified technician to prevent danger.
To Next Page
