IBO BETA User Manual

Instruction manual for electronic circulation pump:
BETA
reading the instruction
manual is obligatory
device damage hazard
electrocution hazard
NOTE: read the manual prior to commencement of use.
For safety reasons, the pump can only be operated by
persons well-familiarised with the manual.
NOTE: the manual is a primary part of the purchase and sale contract.
The user’s failure to observe
the instructions included in the manual is a breach of the contract and excludes
any complaints arising from potential device failure caused by the use that is
inconsistent with instructions of its use.
NOTE: failure to observe the instructions included in the
manual can result in hazard for persons, properties in which
they are installed, environment and the pump itself.
CAUTION! This equipment is not intended for use by persons
(including children) with reduced motor, sensory or mental
capacities, or persons
without experience or not familiarised with the equipment, unless it is
performed under supervision or according to the instruction regarding
operation provided by persons responsible for their safety.
Attention should be paid so that children do not play with the equipment.

IBO BETA Specifications

General

Brand	IBO
Model	BETA
Category	Water Pump
Language	English

Summary

Application and Usage

Pumped Water Contamination Limitations

Pump is intended for clean water; contamination causes wear and failure.

Prohibited Substances for Pumping

Pump is not for hazardous liquids like petrol or oil; warranty void if used.

Oil and Petroleum Derivative Limitations

Pumping oils can damage rubber parts, causing leaks and motor failure.

Pump Installation Guidelines

Electrical Safety During Installation

Always disconnect power supply before installation for safety.

Required Pump Shaft Orientation

Pump shaft must be horizontal for proper operation and bearing longevity.

Consequences of Vertical Shaft Installation

Vertical shaft installation causes bearing wear and pump failure, resulting in paid repair.

Electrical Connection and Safety

Mandatory Earthing Requirement

Pump requires active earthing; lack of it voids manufacturer's liability for damage.

Residual Current Device (RCD) Requirement

Power supply must include a residual current device (RCD) not exceeding 30 mA.

Pump Operation Control and Modes

Operation Mode Selection

User selects one of eleven modes via a switch, classified into five setpoint groups.

Detailed Operation Mode Descriptions

Central Heating Installation Recommendations

Two-Pipe System Setpoint Guidance

Disposable System Setpoint Guidance

Floor Heating Setpoint Guidance

Start-up and Operational Precautions

Installation Tightness and Water Ingress Warning

Ensure installation tightness to prevent leaks; external water ingress can destroy the device.

Minimal Inflow Pressure Requirement

Troubleshooting Common Problems

Pump Not Operating, No Display

Check plug, fuses, and neighborhood power supply; contact service if issues persist.

Pump Not Operating, Panel Displays "--"

Check power supply parameters; if incorrect, contact power plant.

Loud Pump Operation or Noise