ICA SE2000 - 2. SAFETY; 6. TROUBLESHOOTING; 6.1 Information Table; 6.2 Troubleshooting Table

6. KETIDAK NORMALAN
Pesan – pesan berikut ini adalah pesan yang perlu diketahui oleh pengguna ketika
menemukan beberapa masalah, dengan melihat beberapa pesan, pengguna dapat
mengetahui letak permasalahannya.
• Indikator fault nyala, menunjukkan UPS mendeteksi beberapa kesalahan.
• Buzzer berbunyi, menunjukkan UPS memerlukan perhatian.
• Beberapa kesalahan menunjukkan juga statusnya, hal ini membantu pengguna
untuk mendiagnosa letak kesalahan.
6.1. Tabel Informasi
Mode Byp Mode Line Mode Bat
Mode Bat
test
Bus Fault 62 05, 25 01, 21 40, 41
Inv Fault 61, 63 04 24 42
Over Heat 33 06 08 43
OP short \ 16 02 44
Overload \ 03 09 45
Fan Fault 36 28 38 46
Charge Fault 07 07 \ \
Bat Over 11 11 11 11
• Fault operation prevention function, every button has delay function, only
when you press and hold the button for a certain time, required operation can
be activated.
• Ample LCD display information: Various operation environment and working
status are available through the LCD display. You can rapidly judge the fault
reasons, fault part and make the maintenance quickly and conveniently by the
LCD displayed digital fault codes and the fault information codes checking
table.
2. SAFETY
• Even if not connected to main power, high voltage may still presents at UPS
outlets.
• If external battery cord or power cord needs to be replaced, please contact our
service station or franchiser for replacing to avoid fire disaster caused by
insufficient capacity of such items. Don’t dispose of battery or batteries group
in a fire, otherwise, it can cause explosion and harm to people. Don’t open the
battery or do the battery damage, for the liquid spilled from battery is strongly
poisonous and do harmful to body.
• Please avoid short-circuit between battery anode and cathode; otherwise, this
will cause electric shock or fire.
• Don’t dismantle the UPS cover, there is danger of electric shock.
• Don’t touch batteries. Batteries are not isolated with the input circuit, there is
high voltage between the battery terminals and ground.
• Do not connect with the electric equipment such as blower, heater, drilling
machine etc. they may damage the UPS.
Notice :
There presents high voltage in UPS. If there is any abnormal problem
present, please consult the service center and do not attempt to repair the
equipment under any circumstances. The address of service center has
been detailed on the warranty card.
Hal 13 Page 2