STEP 4 – Self-measurement by the patient
1.
the same Icare HOME tonometer.
2.
Do not supervise or interact.
STEP 5 – Measurement of patient’s IOP by HCP
1. The HCP measures the IOP of the patient once with the GAT tonometer.
STEP 6 – Certification
are met:
a.
b.
or less.
c. The positioning of the tonometer was correct during self-use as
determined by the HCP.
Patient ID:
Date (dd mm yy):
CERTIFICATION 0 = Pass; 1 = Fail EYE 0 = Right; 1 = Left, 2 = Both
Icare HOME tonometer Instruction manual for health care professionals
STEP 3 – Supervised patient use of the icare home
1. Load a new probe and carefully, without touching the patient’s eye, choose the eye
and set the distance between the tip of the probe and the center of the cornea for
support positioning as needed. Write the settings down on a support position tag for
the patient.
2.
measurements as instructed and demonstrated.
3.
try again.
4.
If
the patient cannot consistently measure after this point the patient will be
English
Icare HOME tonometer Instruction manual for health care professionals
Icare HOME tonometer Instruction manual for health care professionals ENGLISH
To Next Page
Loading...
