To Next Page
T
Tara SmithJul 31, 2025
How to fix low battery on Icare Pro TA03 Medical Equipment?
- MmikeroweJul 31, 2025
If the Icare Medical Equipment indicates a low battery, the immediate solution is to recharge the device.
How to fix low battery on Icare Pro TA03 Medical Equipment?
If the Icare Medical Equipment indicates a low battery, the immediate solution is to recharge the device.
What to do if Icare Pro TA03 probe hits eyelid or eyelashes?
If the probe of your Icare Medical Equipment hits an eyelid or eyelashes, preventing clean contact with the cornea, ensure the eye is open. Then, press the main button to clear the message and measure again.
Why Icare Medical Equipment shows error with probe distance?
If the distance between the probe and the cornea is too great, or if the probe does not make contact at all when using your Icare Medical Equipment, ensure the distance is within 3-7 mm. Then, press the main button to clear the message and measure again.
What to do if the Icare Medical Equipment says the probe is too close?
If there is too little distance between the probe and the cornea while using the Icare Medical Equipment, make sure the distance is 3-7 mm. Press the main button to clear the message and measure again.
How to fix tilted tonometer on Icare Medical Equipment?
If the Icare Medical Equipment tonometer is tilted too much, position the probe so that it is perpendicular to the center of the cornea. Press the main button to clear the message and measure again.
Why is my Icare Pro TA03 probe not moving correctly?
If the probe of your Icare Medical Equipment does not move correctly, it might be due to a dirty, bent, or twisted probe or probe base. Check that the probe and probe base are intact. Press the main button to clear the message and measure again. If the error repeats, follow the instructions in sections 9 and 10.
What causes Icare Pro TA03 Medical Equipment probe to stop moving smoothly?
If the probe on your Icare Medical Equipment continuously fails to move smoothly or stops moving, this could be because the probe and/or probe base is dirty, bent, or twisted. Follow the instructions in section 9, press the main button to clear the message and measure again.
Step-by-step guide for inserting a single-use probe into the Icare PRO tonometer.
Guidance on positioning the patient and device for accurate IOP measurement alignment.
General| Brand | Icare |
|---|---|
| Model | Pro TA03 |
| Category | Medical Equipment |
| Language | English |
