iCarsoft CR MAX BT - Injector Rate Adjustment; Particle Filter Regeneration

62
NOTE
The data you input should be in the defined range. If the input data is
out of range, the tool will display a warning message “Permissible
adjustment range exceeded.”
[2] Reset Adjustment to 100%
Once the [2] is pressed, the tool will automatically reset the value to
100%.
[3]/[4] Store Data and Exit
When the injection volume adjustment is completed, select [3] and
OK to store the new value in the control units; or select [4] and OK to
retain the old value.
5.8.3 Injector Rate Adjustment
This function is used to adjust the injector rate for individual
cylinders.
1. Tap Injection rate adjustment from the service functions menu.
2. The tool communicates with the vehicle and reads the fault
codes memory. Follow the on-screen instructions to enter the
service function.
3. Tap the corresponding number button to enter new value for
each cylinder.
4. Follow the on-screen instructions to tap on the corresponding
number [1] [2] [3] [4] to enter the new value for the cylinder,
restore the old value, and exit after finish the function.
5.8.4 Particle Filter Regeneration
This function is used to perform the particle filter regeneration.
1. Tap Particle filter regeneration from the service functions
menu.
2. The tool communicates with the vehicle and reads the fault
codes memory. Follow the on-screen instructions to check the
prerequisites before particle filter regeneration, such as the fuel,