What to do if brush motor will not operate on Ice Scrubber?
If the brush motor on your Ice Scrubber isn't working, check these things: ensure the scrub head is lowered to the floor. If not, lower the scrub head. If the battery meter lockout is activated, recharge the batteries. Also, check the brush motor circuit breaker and reset it if it's tripped.
Why is there little or no solution flow in my Ice Scrubber?
If your Ice Scrubber isn't dispensing enough solution, check the following: ensure the ball valve is fully open. If it isn't, turn on the ball valve. Adjust the solution control flow knob. Clean the solution tank filter or flush out the solution hose if they're clogged. If the solution solenoid valve is clogged, remove the valve and clean it.
Do's and don'ts for operating and servicing.
Risks associated with battery handling and charging.
Risks with flammable or reactive materials.
Labeled diagram and list of key machine components.
Connecting battery cables and securing batteries.
Step-by-step guide for starting and running the scrubber.
Lists fault codes, messages, causes, and solutions.
Addresses issues like no operation, poor water pick-up, or short run time.
General| Power Source | Battery |
|---|---|
| Voltage | 24 V |
| Category | Scrubber |
| Working Width | 24 inches |
| Brush Width | 24 inches |
| Solution Tank Capacity | 16 gal |
| Water Tank Capacity | 15 liters |
To Next Page
