How to troubleshoot an Ice SCRUB 50 that does not clean correctly?
If the device does not clean correctly: * Check if the appliance switches on. * Check if enough detergent solution comes out. * Ensure the brush is correctly inserted in the appliance. * Verify that the type of brush used is suitable for the dirt to be cleaned. * Check the condition of the brush, and replace it if necessary.
Why is my Ice Scrubber battery charger not working?
If the battery charger isn't working, consider these potential causes and solutions: 1. Ensure the power cable plug is correctly inserted into the socket in the battery charger (for versions CB). 2. Verify the power supply cable plug is correctly inserted in the mains socket. Try another socket if needed. 3. Confirm the mains power supply characteristics match those required by the battery charger. 4. If the battery charger LEDs are blinking, consult the battery charger's manual to understand the meaning of the signals. 5. Make sure the battery charger is connected to a powered electrical outlet. 6. Ensure the battery charger is connected to the batteries. 7. Check that the mains outlet is functioning properly.
What to do if my Ice Scrubber has a very low operating autonomy?
If your Ice Scrubber has a very low operating autonomy, consider the following: * Check the battery charge level on the control display and perform a complete charging cycle if the charge is critical. * Check if the batteries do not work correctly. * Check if the battery charger does not work. * If the batteries have undergone many discharging and recharging cycles, replace them.
Why is my Ice SCRUB 50 Scrubber device not vacuuming correctly?
If the Ice Scrubber isn't vacuuming correctly: * Empty the recovery tank. * Check the squeegee for obstructions.
What to do if my Ice SCRUB 50 batteries do not work correctly?
If the batteries aren't working correctly: * Ensure the cable bridge is properly connected, and the output voltage is 24V. * Properly connect the battery cable connector to the connector of the general system cable. * Unplug all cables from the batteries, clean the battery terminals, apply a little grease, and restore the electrical connections.
How to fix insufficient detergent solution on the brushes of my Ice Scrubber?
To address insufficient detergent solution on the brushes: * Ensure the detergent solution tap is not partially or completely closed. Move the tap lever control knob downward. * Check that the amount of detergent solution in the water system is sufficient for the task. * Make sure the detergent solution filter is not obstructed. If it is, clean it.
Why does my Ice SCRUB 50 Scrubber produce excessive foam?
If the Ice Scrubber is producing excessive foam: * Check that a low foam detergent has been used. If necessary, add a small quantity of antifoam liquid to the recovery tank. * If the floor is not very dirty, dilute the detergent more.
What to do if my Ice SCRUB 50 Scrubber does not move?
If the Ice Scrubber does not move: * Ensure the dead man's levers are activated by pressing them under the control handlebars. * If it's a traction version, gradually turn the potentiometer adjustment knob clockwise to regulate the appliance speed. * If it's a traction version, engage the electric brake by turning the lever in the traction motor counter-clockwise.
How to fix an Ice SCRUB 50 Scrubber squeegee that does not dry perfectly?
If the squeegee isn't drying perfectly: * Ensure the squeegee is free of obstructions. * Make sure the vacuum hose is free of obstructions. * Make sure the vacuum cap filter is free of obstructions. * Check that the cap on the recovery tank drainage hose is positioned properly. * Check that the recovery tank cover is properly positioned on the appliance.
Why my Ice SCRUB 50 appliance does not proceed straight?
If the appliance does not proceed straight: * Connect the brush correctly. * The brush head is not properly adjusted
To Next Page
General
