15
Water quantity adjustment symbol (versions with CDS):
Used on the control panel to indicate the button for adjusting the water level in the device water circuit.
Brush head command symbol (versions with PM):
Used on the control panel to indicate the brush head command button of the appliance.
Detergent percentage adjustment symbol (versions with CDS):
Used on the control panel to indicate the button for adjusting the percentage of detergent in the device water circuit.
The adjacent image identies the “WORK PANEL” screen, the icon in
the top right corresponds to the charge level of the batteries.
The adjacent image shows the “SCRUBBING AND DRYING” work
screen for the Scrub 50O-55D-65D versions.
The symbol in the middle of the screen identies the type of work
being carried out. In this case, both the brush head unit and the
squeegee unit are in contact with the ground. The working program
selected is the standard one.
The adjacent image shows the “SCRUBBING AND DRYING with
EXTRA PRESSURE" work screen for the PM versions.
The symbol in the middle of the screen identies the type of work
being carried out. In this case, both the brush head unit and the
squeegee unit are in contact with the ground. The extra pressure is
exerted on the brush head unit.
DISPLAY SCREENS (versions Scrub 50C-50O-55D-65D)
The adjacent image shows the “SCRUBBING AND DRYING IN
ECO-MODE” work screen for the Scrub 50O-55D-65D versions.
The symbol in the middle of the screen identies the type of work
being carried out. In this case, both the brush head unit and the
squeegee unit are in contact with the ground. The working program
selected is eco-mode.
To Next Page
Loading...
Need help?
General
