Ice SCRUB 50 - HOUR METER (50 D Versions); HOUR METER (Traction Versions); BATTERY CHARGE LEVEL INDICATOR (50 D Versions); BATTERY CHARGE LEVEL INDICATOR (Traction Versions)

27
PREPARING THE
APPLIANCE
HOUR METER (50D versions)
BATTERY CHARGE LEVEL INDICATOR (50D versions)
HOUR METER (traction versions)
The device's control panel contains the hour meter display (1), which
shows the total usage time (Fig.1). The numbers before the "."
symbol identify hours, while the number that follows it indicates hour
decimals (an hour decimal corresponds to six minutes). The ashing
“:” symbol indicates that the hour meter is counting the appliance's
operating time.
The device's control panel contains the control display, which shows
the total usage time. The numbers before the letter “h” identify the
hours, while the numbers before the letter “m” identify the tenths of
an hour (a tenth of an hour corresponds to six minutes). The ashing
“:” symbol indicates that the hour meter is counting the appliance's
operating time.
The instrument panel contains the display (3) indicating the battery
charge status (Fig.3). The battery charge level is represented by ve
numbers from 0 to 4, where 0 corresponds to a critical charge level
and 4 corresponds to a fully charged battery.
ATTENTION: a few seconds after the battery charge reaches
the critical level, the brush motor switches off automatically.
With the remaining charge it is possible to complete the drying
process before starting the recharge.
The device instrument panel contains the control display. At the top
right of the work screen, there is a graphic symbol (01) representing
the battery charge level indicator (Fig.1). The indicator is composed
of 5 charge levels, each of which represents about 20% of residual
charge. With a residual charge of 20%, the graphic symbol starts
to ash. After a few seconds it appears in larger dimensions in the
middle of the screen (Fig.2); at this point, you must take the machine
to the designated recharging place.
ATTENTION: a few seconds after the battery charge level
reaches 20%, the brush motor switches off automatically. With
the remaining charge it is still possible, however, to complete
the drying process before recharging
ATTENTION: a few seconds after the battery charge level
reaches 10%, the vacuum motor switches off automatically.
The remaining charge is sufcient for moving the appliance to
the designated recharging place
BATTERY CHARGE LEVEL INDICATOR (traction versions)
1
109
3
1
2
1
2
3
1 2
1