Ice SCRUB 50 - Work; STARTING WORK (50 D Versions); SCRUBBING and DRYING (50 D Versions)

34
WORK
STARTING WORK (50D versions)
To start working, do as follows:
1. Make all the checks listed in “PREPARING TO WORK”.
2. Get in the driving seat, behind the machine.
3. Press the main system control button (1) so it is in the “work”
position (Fig.1).
ATTENTION: when the main system control button is
functioning, the LED inside it is activated.
WORK
SCRUBBING AND DRYING (50D versions)
To carry out “SCRUBBING AND DRYING” tasks, proceed as follows:
1. Make all the checks indicated in “STARTING WORK (B
VERSION)”.
2. Lower the brush head unit by pressing the brush head control
pedal (1) on the back of the appliance (Fig.1).
3. Activate the brush head gearmotor using the brush control switch
(2) (Fig.2).
4. Lower the squeegee unit by means of the lever (3) on the back of
the appliance (Fig.3).
5. By activating the dead man's lever (4), the machine will start to
move (Fig.4).
6. Activate the vacuum motor by pressing the relative switch (5) on
the control panel (Fig.5).
7. Activate the supply of detergent solution by pressing the switch
(6) on the control panel (Fig.6).
8. Check the detergent solution tap is fully open. If it isn't, turn the
lever (7) on the back of the appliance (Fig.7).
9. During the rst few metres, check that the detergent solution
is suitable for the work to be carried out. If it isn't, make the
necessary changes after reading the “ADJUSTING THE
DETERGENT SOLUTION (VERSIONS WITHOUT CDS)”
paragraph.
The appliance will now begin to work with full efciency until the
battery is at or until the detergent solution has nished. During the
rst few metres, check that there is sufcient solution and that the
squeegee is drying correctly.
ATTENTION: if during the scrubbing - drying operation the
dead man's lever is released, the brush motor and the
solenoid valve will stop working, the vacuum motor will
continue to work for a few seconds to ensure all the liquid in
the vacuum hose is sucked up.
ATTENTION: when lling the solution tank, it is good practice
to empty the recovery tank using the special drainage hose.
ATTENTION: by pulling the detergent solution ow adjustment
knob downwards, the amount of solution in the water system
will increase (Fig.7).
1
1
ON
1
4
7
2
5 6
4
1 4
7
2
5 6
3