Why my Ice i20NBV Scrubber won't turn on?
Your Ice Scrubber may not be operating due to several reasons. Ensure the control handle bail is pulled. Check if the batteries need charging or replacing, and tighten any loose battery connections. Also, verify if the circuit breaker has tripped and reset it if necessary. If none of these steps work, there may be a faulty button switch.
What to do if Ice Scrubber has poor water pick up?
If your Ice Scrubber isn't picking up water effectively, try these steps: First, drain the recovery tank if it's full. Then, tighten the drain hose cap and clean the float shut-off screen in the recovery tank. Ensure the squeegee assembly is free from clogs. Check the squeegee blades for wear and replace or rotate them if needed. Adjust the squeegee blade height for correct deflection and secure any loose vacuum hose connections. Clear any clogs from the vacuum hose and replace the hose if damaged. Make sure the recovery tank cover is properly positioned and replace the seal if damaged. Finally, recharge batteries if the charge is low.
How to fix Ice i20NBV when there is little or no solution flow?
If your Ice Scrubber has little to no solution flow, check that the ball valve is fully open. Adjust the solution flow control knob to a higher setting. Clean the solution tank filter and flush out the solution hose to remove any clogs. If the issue persists, the solution solenoid valve may be clogged and needs cleaning.
Why does my Ice i20NBV have a short run time?
A short run time for your Ice Scrubber could be due to a low battery charge, so fully recharge the batteries. If the problem continues, the batteries may be defective and need replacement. Alternatively, the battery charger itself might be faulty and require repair or replacement.
What to do if the brush motor of Ice i20NBV will not operate?
If the brush motor on your Ice Scrubber isn't working, first ensure the scrub head is lowered to the floor. If that's not the issue, there may be a faulty scrub head (up/down) switch, control handle bail switch, brush motor, or its wiring. Also, worn motor carbon brushes may be the cause.
What to do if the vacuum motor of Ice i20NBV Scrubber will not operate?
If the vacuum motor isn't working, it could be due to a faulty vacuum motor or its wiring, or worn motor carbon brushes.
General| Model | i20NBV |
|---|---|
| Category | Scrubber |
| Working Width | 20 inches |
| Solution Tank | 15 gallons |
| Recovery Tank | 15 gallons |
| Power Supply | Battery |
| Power Source | Battery |
| Battery Voltage | 24V |
| Brush Width | 20 inches |
| Tank Capacity | 15 gallons |
| Noise Level | 68 dB |
To Next Page
