iCharger 458DUO - Important Notes; Charging Principles & Regenerative Modes

458DUO
Dual Balance Charger/Discharger/DC Power
- 35 -
Important Notes
The Charging Principle for Reflex Charge Mode
Power Regenerative Mode
Channel Regenerative Mode
Channel Regenerative Mode is the feature for discharging from one channel to another channel, which supports resistor
discharge, bulbs discharge, and charging battery.
Resistance or Bulbs
Reflex charge mode only supports NiMH and Pb battery. It
does not support lithium battery. Using reflex charge mode
to charge battery can reduce effectively the heating of the
battery. Go to the MEMORY SETUP → Charge → Chg
Mode to select Reflex mode.
which is when the power supply for the charger acts as
"battery power", the charger will regenerative charge for
"battery power" during the process to discharge the battery.
Go to MEMORYSETUP → Discharge → Regenerative Mode
→ To input.
1: Regenerative power
2: Regenerative voltage limit
3: Regenerative current limit
1
Lo
w
Vo
lta
ge
Li
mi
t:
9V
-4
8V
;
de
fa
ult
:
10
V
3
1. Connect the resistance or bulbs to any channel of the
charger;
2. In another channel of the charger, MEMORY SETUP →
Discharge → Regenerative Mode → To channel, to
select Resistance or bulbs，then connect the battery for
discharging to this channel, and start the discharge
program to discharge the battery. Press STOP/START
button to end the program during the period.
458DUO