Ickle Bubba Mercury - Maintenance and Uninstallation; Uninstallation Procedures; Cleaning Instructions

Uninstallation of the carrier and base
1. To remove the car seat from the base, press the
Release button while lifting the car seat by the handle.
2. To remove the base, pull the two orange buttons (1)
towards you (Picture 21) to release the two ISOFIX
connectors from the vehicle anchors.
3. Pull up the latch and push the support leg inwards
(Picture 20).
Installing the car seat with vehicle seat belt
1. Place the infant car seat onto the vehicle seat, facing
the rear of the vehicle. The seat is not suitable for use
with a two-pointed or lap seatbelt. Securing with a
two-point seatbelt could result in serious or fatal
injuries to the child in the event of an accident.
2. Loosen shoulder belts by pressing the Centre
function adjustment button and simultaneously pulling
both shoulder belts up. (Picture 9)
3. Put your child into the child seat, place shoulder
belt directly over your child’s shoulders and
ensure the shoulder belts are not twisted. Place both
buckle tongues together and lock them in place in belt
buckle with an audible “CLICK” (Picture 10). Pull carefully
on the central adjustment belt in order to tighten
shoulder belts until they fit snugly (Picture 11).
4. Unfold the sun canopy by pulling on the plastic cover.
To fold up, push the sun canopy back to the start
position.
5. Pull out the vehicle seatbelt and feed it over the infant
car seat. Ensure the lap belt is secured through the two
side webbing guides (1) on the front of the infant car
seat, and the shoulder belt is secured through the blue
central belt guide (3) on the back. Lock the buckle
tongue in place in vehicle seatbelt (Picture 22/23/24).
Warning: If the buckle of the vehicle seat belt (2) is too
close to the infant car seat, the infant car seat will not be
fastened securely. In the event of this happening, choose
another sear in the vehicle for the infant car seat.
21
22
Cleaning
The cover and the belt can be cleaned with a clean
cloth and some lukewarm soapy water. The plastic parts
can be cleaned with a mild detergent and warm water.