10 11icklebubba.com icklebubba.com
Installation of Group 0+(birth-13kg), Group I(9-18kg)
with ISOFIX & Top tether
• The top tether strap should go through the belt
guides on both sides, then lock the hook on the
anchor bracket.
• Pull out the top tether and press the tether strap
release button to extend the strap until it is long
enough to hook onto the User-ready tether
anchorage behind.
• Hook the tether strap hook onto the User-ready
anchorages. There maybe 3 anchorages for the
hook, please find one in your favor.
• Pull the tether strap on the other end back to
tighten the Top tether.
CAUTION: If the top tether is tightened correctly, an
ok mark will show up on the other end of the strap
release button, please check it.
• Press the top tether adjustor button then
release it.
• It's easy to release the adjustor button to
achieve the rotation function when baby in the
vehicle.
How to adjust the height of the shoulder belts
If your child is big enough and can not fit the shoulder belts, you should adjust it or take it away.
• Pressing the button on the central
adjuster and pull the shoulder
belts out
• Remove the end of shoulder
belts from the spreader bar
• Pull belts out from the slots
Harness buckle removal
• Locate the metal buckle strap retainer on
bottom of the shell.
• Pull retainer away from child restraint to loosen, turn
the retainer so that the short side will go through the
slot in the restraint shell. Push the retainer through
slots in the shell and cover to the top of the restraint.
Uninstall harness system.
Installation of Group 2/3 (15-36kg)
Note: The Baby insert, Harness strap, Harness buckle, Buckle pads,
Shoulder pads & Shoulder belts axle should be stored away safely for future
use (see 5.1 Removing the 5-point harness system and cover).
WARNING!
Do not to use any load bearing contact points other than
those described in the instructions and marked in the child
restraint.
To Next Page
Loading...
