8 9icklebubba.com icklebubba.com
Securing your baby using the harness
• Loose the harness straps by pressing the release button and pulling the harness straps as far
as you can. NOTE: Do not pull the Shoulder pads.
• Open the harness buckle, then fix the harness straps into the belt guide band. Put the baby into
the car seat.
• The correct height of the shoulder belts is attained when the belt disappears into the shell
slightly above the shoulder of the child. Make sure that the harness straps fit properly
• Slide buckle tongues together and insert them in the buckle with an audible sound "click".
• Pull the straps tight by the harness adjustment strap, and make sure the tightness is
comfortable to your kid.
CAUTION: Do not twist or interchange the harness straps.
Tightening the harness
CAUTION: Pull the strap end straight towards you, not
upwards or downwards.
Please pay attention to the strap end. Whilst traveling
(especially outside the car) it should always be attached
to the cover.
Checklist to ensure that your baby is
buckled up correctly
IMPORTANT: For the safety of your baby, please ensure that:
• The harness straps of the car seat are comfortable
but firm fit around your child.
• The harness straps are adjusted correctly.
• The harness straps are not twisted.
• The buckle tongues are engaged in the harness buckle.
Installation in the vehicle
Please do not leave your child unattended in the child safety seat in the vehicle.
For the protection of all vehicle occupants:
In the case of an emergency stop or an accident unsecured persons or objects may cause
injury to other vehicle occupants. Please always check that:
• The backrests of the vehicle seats are locked (i.e.that a foldable rear seat bench latch is
engaged).
• All heavy or sharp-edged objects in the vehicle(e.g. on the parcel shelf) are secured.
• All persons in the vehicle have their seat belts fastened.
• The child safety seat is always secured when it is in the vehicle, even if no child is being
transported.
To protect your vehicle
Some vehicle seat covers of sensitive materials(e.g. velour, leather, etc.) may develop wear
marks when child seats are used. This can be avoided by placing a blanket or towel under the
child seat.
Installation of Group 0+(birth-13kg), Group I (9-18kg)
with ISOFIX and Top tether
IMPORTANT: First please check if there are 2 ISOFIX anchorings in the perpendicular
intersection of the vehicle seat back and seat cushion, and the user-ready top tether
anchoring behind the vehicle seat.
Tips: The user-ready tether anchorage is usually permanently installed on the inner rear
luggage shelf or on the vehicle floor.
For more details you could read your vehicle guidelines or contact the vehicle manufacturer.
• Rotate by pressing the rotation button and turn the seat into the rearward facing position.
• Press the ISOFIX release button and push the ISO FIX connectors forward as far as possible.
• Push the ISOFIX connectors directly into the anchorages until you hear an audible sound "click"
• Press the rotation button and turn the seat against the direction of travel, as rearward facing
position. Grasp the recline button and press the child seat into the most reclined position
• Tip: If the ISOFIX connectors are correctly installed, the Release button will pop out, and you
can see a clear green mark on it.
• Grasp the seat body to check the seat if it is fastened tightly or shakes.
If the seat shakes and the ISOFIX connectors are pulled out, please repeat
the above steps and install it again.
To Next Page
Loading...
