8 9icklebubba.com icklebubba.com
Brake Bar Installation
Rear Wheel Installation
1
3 4
2
Brake Bar Installation
1. Please ensure the chassis is unfolded before installing the brake bar and wheels.
Attach the brake bar to the rear of the chassis as shown above.
2. Ensure the silver locking clips are visible on each side and test this by pulling the brake
bar downwards once it has been installed.
Rear Wheel Installation
3. To attach the rear wheels simply press the centre button whilst pushing on to each side of
the axle. Test this by trying to remove the wheels without pressing the centre button.
4. To disassemble the wheels push the centre button and pull.
Front Wheel Installation
1 2
1. Keep holding the front wheel button and attach the front wheel onto the chassis.
Repeat other side.
2. Please ensure you test your installation by pulling the front wheel down a few times before using.
NOTE: Please ensure that the front wheels are locked when using on rough terrain.
To take the front wheel off push the silver button and pull down on the wheel.
3
To Next Page
Loading...
