Icom IC-207H - Page 24

3 SETTING A FREQUENCY
¢ &
Ei Using the keypad [4] Push & keys to input a frequency.
¢ When a digit is mistakenly input, push [ENT] to clear the np
f—-\ The frequency can be directly set via numeral then input from the 1st digit.
ENT keys on the microphone. * Pushing [CLR] clears input digits and retrieves the frequency.
\c) [5] Push [A] or [W] to make adjustments below the 10 kt
Push [BAND] to set the operating band, if necessary. digit, desiad, :
Push [VFO] to select VFO mode.
Push [ENT] to activate the keypad for digit input.
[EXAMPLE]: Setting the frequency to 145.360 MHz.
then
(@o
ae
=
|
~! -5-9—~
1
t
[EXAMPLE]: Setting the frequency to 446.325 MHz. (When the 25 kHz tuning step is selected in UHF.)
9) then a0